Ifyou have a G28 code on your audi you might have to replace it. I show you how to find that sensor and where the connector is since I had a hard time findi

On2009 VW Passatwagon 2.0T where is the exact location of the knock sensor 1 designated as G61 by VW? About how much time does a WV/Audi garage mechanic need to change the crankshaft position sensor on an Audi A4 1.8T 2001. I just got charged for 2hrs, 50min labor. Wheres the crank sensor located on vw golf turbo 2001 'Y' Whereis the crankshaft position sensor located on a 2009 Audi a4 2.0 liter. 2009 Audi A4. Asked by gtrzn in Tampa, FL on . August 05, 2014. 0 replies Report. Answer. Is there a recall on a4 2.0T quattro 2011 suprdan s4; The camshaft adjuster solenoid was replaced should the timing chain have been done at the same time;
Anecdotally the code may be more commonly seen on Toyota, Lexus, Hyundai, Audi VW Volkswagen, Chevrolet, Scion and Ford vehicles, but any make vehicle can be affected. Specific troubleshooting steps will vary depending on the vehicle. This P0346 code basically means that the powertrain control module (PCM) detected a problem with the camshaft

Itis under the black plastic cover for the timing belt near the meatl tab with the engine code engraved. Procedure -. 1)remove tb cover, set aside. 2)disconnect the plug connector. 3)use a 10mm socket to remove the two 10mm bolts that secure the sensor (righty tighty, lefty loosey) 4) pull CPS out. To install, just do the above steps in

Youwill need: - Audi/ VW O-rings part number WHT-002-789 (qty, 4). They go anywhere from about $3-$4.50/ each depending on the dealer/ online store) - Torx bit set (forgot the size now but it's a small one I used with my 1/8" drive ratchet), ratchet, 3" extension. - Brake parts cleaner and rags.

sR4zQ.
  • 2htmin25yk.pages.dev/191
  • 2htmin25yk.pages.dev/121
  • 2htmin25yk.pages.dev/284
  • 2htmin25yk.pages.dev/5
  • 2htmin25yk.pages.dev/529
  • 2htmin25yk.pages.dev/449
  • 2htmin25yk.pages.dev/8
  • 2htmin25yk.pages.dev/205

    • 2009 audi a4 camshaft position sensor location